P0577
Cruise Control Input Circuit High
Cruise control buttons are almost always a resistor ladder on one or two signal lines, each button giving its own voltage; the module reading it (GM and Saab from about 2010: the body module; FCA: steering column module or PCM) sends the button state to the engine module over CAN. CARB names cruise control as the example of an emission-neutral diagnosis – it is simply switched off – so GM lists all these codes as type C and Ford as non-MIL: no warning lamp, the engine runs normally. P0577 means the input signal is above its upper limit – an open signal or switch ground (often in the clockspring) or a short to positive. FCA's ladder treats over 4.706 V as circuit high, with about 4.54 V at rest. No manufacturer document available to us uses this code. For line A makers use P0581.
Possible causes
- Signal or switch ground open (clockspring) high
- Signal shorted to positive medium
- Module faulty low
Symptoms
- Cruise control inoperative
- Cruise control locked out
- No check engine light, engine runs normally
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0577
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.