P0575
Cruise Control Input Circuit
Cruise control buttons are almost always a resistor ladder on one or two signal lines, each button giving its own voltage; the module reading it (GM and Saab from about 2010: the body module; FCA: steering column module or PCM) sends the button state to the engine module over CAN. CARB names cruise control as the example of an emission-neutral diagnosis – it is simply switched off – so GM lists all these codes as type C and Ford as non-MIL: no warning lamp, the engine runs normally. At GM and Saab P0575 is not an analogue circuit fault but the plausibility of the CAN message carrying the button state from the body module: wrong checksum or rolling count in 9 of 17 messages (2014: 3 of 10 frames). Other makers use it literally as a general input circuit fault with P0576/P0577.
Possible causes
- Body module faulty or software (invalid message) medium
- CAN disturbance (connectors, wires, termination) medium
- Steering wheel switch fault (B3794 in the body module) medium
- Engine module low
Symptoms
- Cruise control inoperative, possibly further U codes
- Cruise control locked out
- No check engine light, engine runs normally
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0575
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.