OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0570

Cruise Control Accelerate Signal

Cruise control buttons are almost always a resistor ladder on one or two signal lines, each button giving its own voltage; the module reading it (GM and Saab from about 2010: the body module; FCA: steering column module or PCM) sends the button state to the engine module over CAN. CARB names cruise control as the example of an emission-neutral diagnosis – it is simply switched off – so GM lists all these codes as type C and Ford as non-MIL: no warning lamp, the engine runs normally. P0570 classically concerns the accelerate (plus) button. Ford's 2023 diesel uses it differently, only with adaptive cruise: the CAN message with the maximum acceleration request from the radar module to the engine module is faulty, checked every 10 ms, fault after 0.1 s. GM does not use P0570 (resume and accelerate share P0567).

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / 70

Possible causes

  • Accelerate button faulty (conventional systems) medium
  • Ford adaptive cruise: CAN fault or software of radar module or PCM medium
  • Contact problem in steering wheel switch or clockspring medium
  • Module faulty low

Symptoms

  • Cruise control does not accelerate, adaptive cruise unavailable
  • Cruise control locked out
  • No check engine light, engine runs normally

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0570

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication