P0565
Cruise Control On Signal
Cruise control buttons are almost always a resistor ladder on one or two signal lines, each button giving its own voltage; the module reading it (GM and Saab from about 2010: the body module; FCA: steering column module or PCM) sends the button state to the engine module over CAN. CARB names cruise control as the example of an emission-neutral diagnosis – it is simply switched off – so GM lists all these codes as type C and Ford as non-MIL: no warning lamp, the engine runs normally. P0565 concerns the on signal. GM sets it when the on/off button is reported pressed for over 20 s. Subaru (also in the Saab 9-2X) uses another principle and the warning lamp after two trips: cruise is reported active below 20 km/h for 10 s, where it cannot be active; the signal goes to the automatic transmission.
Possible causes
- On/off button stuck or faulty high
- Moisture or wear in the steering wheel switch medium
- Contact resistance in clockspring or steering wheel connector medium
- Body module or cruise module low
Symptoms
- Cruise control inoperative, indicator permanently on or off
- Cruise control locked out
- No check engine light, engine runs normally
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0565
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG03A Engine Diagnostics.pdf
- saabwisonline.com/9-2x-9346/2005/0-general/general-diagnostics-2-0t/diagnostic-trouble-code-dtc-detecting-criteria/fault-diagnosis-fault-codes/dtc-p0565-cruise-control-on-signal
- saabwisonline.com/9-2x-9346/2005/2-engine/engine-diagnostics-2-0t/diagnostic-procedure-with-diagnostic-trouble-code-dtc/fault-diagnosis-fault-codes/dtc-p0565-cruise-control-on-signal