P0558
Brake Booster Pressure Sensor Circuit High
The brake booster pressure sensor (5 V reference, signal, ground) measures the vacuum in the brake booster. On direct-injection, turbo, stop-start and hybrid engines intake vacuum is scarce, so the engine module watches it and creates vacuum when needed – closing the throttle, suppressing engine stop or running an electric vacuum pump. That makes it an input to idle and throttle control. P0558 means the signal voltage is too high: GM 2018 above 95 % of the reference in 2000 of 2400 samples (about 30 s), GM 2006 above 4.89 V; type B, two trips. Typical are a signal shorted to 5 V or battery voltage or an open sensor ground. A real loss of vacuum does not set P0558 but P0556 or, depending on the maker, P050F.
Possible causes
- Sensor ground open (connector, wire) high
- Signal shorted to 5 V reference or battery voltage medium
- Sensor faulty medium
- Engine module low
Symptoms
- Check engine light or brake booster warning
- Stop-start inactive
- Often no change in driving
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0558
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.