P0555
Brake Booster Pressure Sensor Circuit
The brake booster pressure sensor (5 V reference, signal, ground) measures the vacuum in the brake booster. On direct-injection, turbo, stop-start and hybrid engines intake vacuum is scarce, so the engine module watches it and creates vacuum when needed – closing the throttle, suppressing engine stop or running an electric vacuum pump. That makes it an input to idle and throttle control. P0555 is the general circuit fault without low/high distinction. No manufacturer document available to us uses it; GM splits circuit faults into P0557 and P0558. The module then assumes a substitute value and keeps vacuum available as a precaution.
Possible causes
- Connector or wire to the sensor open or corroded high
- Sensor faulty medium
- 5 V reference disturbed (short at another sensor on the same reference) medium
- Engine module low
Symptoms
- Check engine light or brake booster warning
- Stop-start inactive
- Often no change in driving
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0555
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.