P0554
Power Steering Pressure Sensor/Switch Circuit Intermittent
Hydraulic power steering has a pressure switch or sensor on the high-pressure line; when the wheel is turned at standstill, pump pressure and engine load rise sharply, so the engine module raises idle air in advance to stop the engine stalling. That makes it an input to idle control under CARB. Switches (Saab, Mitsubishi) ground a pull-up; analogue 5 V sensors (Toyota) give about 0.45 V at zero pressure. GM's and Ford's tables do not use P0550–P0554. P0554 means the signal flutters. Mitsubishi sets it when the switch changes state at 10 Hz or more for 20 s above 50 km/h – no sound switch switches that fast. Causes are electrical (loose contact) as well as hydraulic: pressure pulsation from air or low fluid, or an unsteady pump.
Possible causes
- Loose contact or corrosion at connector or wire high
- Low fluid or air in the system (pressure pulsation) medium
- Pressure switch worn (contact bounce) medium
- Steering pump delivering unsteady pressure low
Symptoms
- Idle speed jumping or fluctuating
- Check engine light depending on the maker
- Steering pump noise (air, low fluid)
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0554
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.