P0553
Power Steering Pressure Sensor/Switch Circuit High
Hydraulic power steering has a pressure switch or sensor on the high-pressure line; when the wheel is turned at standstill, pump pressure and engine load rise sharply, so the engine module raises idle air in advance to stop the engine stalling. That makes it an input to idle control under CARB. Switches (Saab, Mitsubishi) ground a pull-up; analogue 5 V sensors (Toyota) give about 0.45 V at zero pressure. GM's and Ford's tables do not use P0550–P0554. P0553 means the signal is above range – usually an open sensor ground or signal pulled up, a short to 5 V or battery, or a faulty sensor; high pressure alone does not reach the limit (Toyota's sensor gives 4.05 V at 7000 kPa). Toyota's 2007–08 Tundra set it from a series sensor fault.
Possible causes
- Sensor faulty (Tundra 2007–08 series part) high
- Sensor ground or signal line open medium
- Signal shorted to voltage low
- Engine module low
Symptoms
- Check engine light on (Toyota)
- Permanently raised idle or no load pre-control
- Possible fluid leak at the sensor
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0553
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.