P0552
Power Steering Pressure Sensor/Switch Circuit Low
Hydraulic power steering has a pressure switch or sensor on the high-pressure line; when the wheel is turned at standstill, pump pressure and engine load rise sharply, so the engine module raises idle air in advance to stop the engine stalling. That makes it an input to idle control under CARB. Switches (Saab, Mitsubishi) ground a pull-up; analogue 5 V sensors (Toyota) give about 0.45 V at zero pressure. GM's and Ford's tables do not use P0550–P0554. P0552 means the signal of an analogue sensor is below range – an open 5 V supply, a signal shorted to ground or a faulty sensor, not low pressure. Toyota's 2007–08 Tundra set P0552/P0553 from a series sensor fault and replaced it with a revised part, with the warning lamp on.
Possible causes
- Sensor faulty (Tundra 2007–08 series part) high
- 5 V supply open or signal shorted to ground medium
- Connector corroded or oily (leaking sensor) medium
- Engine module 5 V reference low
Symptoms
- Check engine light on (Toyota)
- Idle drops when steering at standstill
- Possible fluid leak at the sensor
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0552
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.