OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0551

Power Steering Pressure Sensor/Switch Circuit Range/Performance

Hydraulic power steering has a pressure switch or sensor on the high-pressure line; when the wheel is turned at standstill, pump pressure and engine load rise sharply, so the engine module raises idle air in advance to stop the engine stalling. That makes it an input to idle control under CARB. Switches (Saab, Mitsubishi) ground a pull-up; analogue 5 V sensors (Toyota) give about 0.45 V at zero pressure. GM's and Ford's tables do not use P0550–P0554. P0551 means the switch reports high pressure where that is implausible – at speed there is hardly any steering. Mitsubishi sets it when the switch stays on through 10 drive-and-stop cycles; Saab's Trionic T8 after 600 s above 50 km/h, keeping raised idle as substitute and without warning lamp.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / 51

Possible causes

  • Pressure switch stuck closed or faulty internally high
  • Signal line shorted to ground (ground means active) medium
  • Permanently high pressure (steering valve sticking, kinked line) low
  • Vehicle speed signal faulty (Saab depends on P0501) low

Symptoms

  • Permanently slightly raised idle
  • No load compensation when steering
  • Check engine light depending on the maker (Saab: none)

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0551

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication