P0550
Power Steering Pressure Sensor/Switch Circuit
Hydraulic power steering has a pressure switch or sensor on the high-pressure line; when the wheel is turned at standstill, pump pressure and engine load rise sharply, so the engine module raises idle air in advance to stop the engine stalling. That makes it an input to idle control under CARB. Switches (Saab, Mitsubishi) ground a pull-up; analogue 5 V sensors (Toyota) give about 0.45 V at zero pressure. GM's and Ford's tables do not use P0550–P0554. P0550 is the general circuit fault. No manufacturer document available to us uses it. Without the signal the engine can drop or stall at full lock, or the module raises idle permanently as a substitute.
Possible causes
- Connector or wire open or corroded (splash zone at the pump) high
- Sensor or switch faulty, often also leaking high
- 5 V reference or ground disturbed medium
- Engine module low
Symptoms
- Check engine light (depending on the maker)
- Idle drops when steering at standstill, engine may stall
- Raised idle (substitute value)
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0550
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.