OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P054A

Cold Start B Camshaft Position Timing Over-Advanced Bank 1

Camshaft B is the exhaust camshaft. During catalyst heating after a cold start some engines set it to a specific position; CARB requires such commanded elements to be monitored with their own codes, separate from the normal cam codes. Ford watches the deviation with an averaged variance index for each direction; GM (Saab 9-4X V6) uses only the retard codes, above 6° for 1 s or 4 s cumulative, type B. The commonest cause is oil pressure building too slowly when cold. P054A means bank 1 was too far advanced. Mercedes (M276) traces it to slow oil pressure – 1 bar should be reached after about 3 s; Audi (Q5 3.2) and VW (Atlas 3.6 and 2.0 T) fixed it by software.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / 4A

Possible causes

  • Oil pressure building too slowly when cold (oil level, viscosity, pick-up, pump) high
  • Exhaust oil control valve sticking or screens clogged medium
  • Module software (threshold too tight) medium
  • Cam phaser defective, locking pin low
  • Timing chain stretched or misassembled low

Symptoms

  • Check engine light on, usually without noticeable symptom
  • Brief rattle on cold start
  • Rough idle while warming up

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P054A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication