P0548
Exhaust Gas Temperature Sensor Circuit Low Bank 2 Sensor 1
The exhaust gas temperature sensor is a thermistor in a voltage divider with the module's pull-up resistor; the first one (sensor 1) sits before the turbocharger, the oxidation catalyst or after it depending on the maker. Diesels use it for particulate filter regeneration and component protection; CARB names it explicitly as a monitored input. Bank 2 sensor 1 exists only on V engines with a separate exhaust path per cylinder bank. No manufacturer document available to us uses this code; the thresholds known for bank 1 apply by analogy. P0548 means the signal is below range, usually a short to ground – for bank 1 GM uses below 142 Ω, Ford below 0.10 V.
Possible causes
- Signal line shorted to ground high
- Sensor shorted internally medium
- Connector damp or corroded medium
- Engine module low
Symptoms
- Check engine light on
- Particulate filter regeneration missing, filter warning
- Possible power reduction
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0548
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- hella.com/techworld/au/technical/sensors-and-actuators/checking-the-exhaust-gas-temperature-sensor/
- gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG04 Engine Diagnostics.pdf
- fordservicecontent.com/Ford_Content/catalog/motorcraft/obd-summary-diesel-2023.pdf
- law.cornell.edu/regulations/california/13-CCR-1968.2