P0546
Exhaust Gas Temperature Sensor Circuit High Bank 1 Sensor 1
The exhaust gas temperature sensor is a thermistor in a voltage divider with the module's pull-up resistor; the first one (sensor 1) sits before the turbocharger, the oxidation catalyst or after it depending on the maker. Diesels use it for particulate filter regeneration and component protection; CARB names it explicitly as a monitored input. P0546 means the signal is above range: GM L5P above 922 Ω, GM LML above 2.21 V, Ford 6.7 L above 2.66 V for about 2 s, Saab 9-5 2.0 TiD above 4.9 V for 1 s. Most often an open circuit pulled up to the reference, otherwise a short to positive; live data then show −40 °C or the maximum. The module uses a substitute value and blocks filter regeneration.
Possible causes
- Sensor element or internal lead open (vibration, heat) high
- Connector loose or corroded, broken wire high
- Signal line shorted to positive low
- Engine module low
Symptoms
- Check engine light on
- Particulate filter regeneration missing, filter warning
- Possible power reduction
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0546
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- fordservicecontent.com/Ford_Content/catalog/motorcraft/obd-summary-diesel-2023.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG04 Engine Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2014/14OBDG10 Engine Diagnostics.pdf
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-diesel/fault-diagnosis-diagnostic-trouble-codes/dtc-p0545-or-p0546
- hella.com/techworld/au/technical/sensors-and-actuators/checking-the-exhaust-gas-temperature-sensor/