P0542
Intake Air Heater A Circuit High
Some diesels – typically Cummins engines in Ram pick-ups and commercial vehicles, and Iveco – heat the intake air with a grid heater in the intake manifold instead of or alongside glow plugs. It draws very high current through a relay (on recent Ram a solid-state relay) and is switched by the engine module before and after starting; CARB requires cold-start aids to be monitored. P0542 means the voltage stays high although the heater is commanded on – a control line shorted to positive or a relay that does not switch. A shorted or welded relay can also power the heater permanently; Ram recalled 6.7 L Cummins trucks because a shorted heater relay could start a fire. No manufacturer document available to us uses this code; GM's Duramax LML has an intake heater but reports it under its own codes P154A–P154D.
Possible causes
- Heater relay faulty (solid-state relay shorted, contacts stuck) high
- Control line shorted to positive, harness chafed on a power cable medium
- Power circuit overheated, cable scorched medium
- Engine module driver low
Symptoms
- Check engine light on
- Battery drained when heater stays on
- Burning smell or scorched wiring at the relay
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0542
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.