P0540
Intake Air Heater A Circuit
Some diesels – typically Cummins engines in Ram pick-ups and commercial vehicles, and Iveco – heat the intake air with a grid heater in the intake manifold instead of or alongside glow plugs. It draws very high current through a relay (on recent Ram a solid-state relay) and is switched by the engine module before and after starting; CARB requires cold-start aids to be monitored. Cummins checks it by the manifold temperature rise, Iveco by the battery voltage dip when the relay switches. P0540 is the general circuit fault of heater A without low/high assignment. No manufacturer document available to us uses this code; GM's Duramax LML has an intake heater but reports it under its own codes P154A–P154D.
Possible causes
- Heater relay faulty (contacts welded or burnt, solid-state relay shorted) high
- Heating grid burnt out medium
- Power cable or ring terminal corroded or overheated, control connector medium
- Engine module driver low
Symptoms
- Check engine light on
- Hard cold start, white smoke, rough cold idle
- With welded relay: battery drained, heater stays on
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0540
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.