P0535
A/C Evaporator Temperature Sensor Circuit
The evaporator temperature sensor, an NTC thermistor behind the evaporator, prevents icing: near 0–3 °C the compressor is switched off or reduced. Usually the climate module reads it and reports body codes; P0535–P0539 only arise where the engine module controls the compressor and reads the sensor. P0535 is the general circuit fault; the compressor is usually locked out or run with a substitute value. No manufacturer document available to us uses this code; the description follows CARB's input component rules.
Possible causes
- Sensor faulty high
- Connector corroded by condensate high
- Wire open or shorted medium
- Engine module low
Symptoms
- Air conditioning not or weakly cooling
- Evaporator icing, airflow decreasing
- Compressor cycling unusually
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0535
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.