P0532
A/C Refrigerant Pressure Sensor A Circuit Low
The engine module reads the high-side refrigerant pressure sensor (5 V reference, signal rising with pressure) to switch or regulate the compressor, raise the radiator fans at high pressure and pre-control the compressor load at idle. CARB therefore requires A/C components to be monitored where they alter fuel or ignition control or feed other diagnoses (from 2006–2008). P0532 means the signal voltage is too low – GM below 3 % of the 5 V reference in 80 of 100 samples (about 2 s), from a signal shorted to ground, an open signal line or a lost 5 V reference; an empty system at ambient pressure usually still reads in range. The compressor is locked out. Warning lamp: GM type C without, Saab 9-4X with, Ford depending on vehicle.
Possible causes
- Signal line open or shorted to ground high
- Pressure sensor faulty high
- Connector corroded or loose medium
- 5 V reference shorted or failed medium
Symptoms
- Air conditioning not cooling (compressor off)
- Radiator fan running permanently
- Check engine light (depending on the maker)
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0532
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG03A Engine Diagnostics.pdf
- saabwisonline.com/9-4x/2011/8-body/automatic-climate-control-acc/fault-diagnosis-diagnostic-trouble-codes/dtc-p0532-or-p0533
- roushcleantech.com/wp-content/uploads/sites/all/themes/roushcleantech/pdf/diagnosticmanuals/Roush_CleanTech _Diagnostics_Manual-DA_8.5.18.pdf