P0520
Engine Oil Pressure Sensor/Switch A Circuit
The oil pressure sensor matters for emissions control because modern engines use it as an input – for two-stage or regulated oil pumps, hydraulic cam phasers and GM's cylinder deactivation, whose lifters switch by oil pressure. P0520 is the general circuit fault, used differently: Ford petrol and diesel engines set it for the digital SENT sensor when it reports an internal fault, does not initialise or sends values out of range (lost communication is U0600), after 5 s. GM's 1.4 L turbo with an oil pressure switch sets it when the switch reports pressure although the engine has been off long enough to be pressureless – type C, without warning lamp.
Possible causes
- Sensor or switch faulty internally high
- Connector corroded or oily (oil creeping through a leaking sensor) medium
- Signal line open or shorted to ground medium
- 5 V reference or supply faulty (usually with other sensor codes) low
Symptoms
- Check engine light (depending on the maker)
- Oil pressure gauge or warning wrong
- Cam phasing or cylinder deactivation possibly disabled
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0520
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.