OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0511

Idle Air Control Circuit

CARB requires the idle speed control to be monitored: petrol engines must flag a fault if the target idle speed is not reached within +200/−100 rpm, diesels within ±30 %. Older engines use a separate idle air control valve that bypasses the closed throttle; with electronic throttle the throttle itself controls idle and no separate valve exists. P0511 is the general circuit fault of the idle valve – open, short to ground or to positive – without separating low and high, which CARB permits. Ford (up to about 2012, engines with an idle valve) has the output stage report it via a diagnostic status bit, continuously. Valve types are PWM solenoid or rotary valves (two wires) or stepper motors (four wires, typical of GM). Without a working valve the engine runs on a fixed bypass or the mechanical stop and may stall.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / 11

Possible causes

  • Idle valve faulty (coil open or shorted) high
  • Wire open or shorted medium
  • Connector corroded, pins pushed back medium
  • Driver in the engine module low

Symptoms

  • Idle too high, too low or fluctuating
  • Engine stalls at idle
  • Check engine light on

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0511

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication