OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0506

Idle Control System RPM - Lower Than Expected

CARB requires the idle speed control to be monitored: petrol engines must flag a fault if the target idle speed is not reached within +200/−100 rpm, diesels within ±30 %. Older engines use a separate idle air control valve that bypasses the closed throttle; with electronic throttle the throttle itself controls idle and no separate valve exists. P0506 means the idle speed of the warm engine at standstill stays too low despite fully used control. GM uses more than 91 rpm filtered for 10 s (MIL after two trips), Ford petrol −100 rpm plus a correction above 1 lb/min, Ford diesel −100 rpm for 5 s, Subaru −100 rpm with the correction at its limit for 10 s three times. Typical are deposits, extra load or a restricted intake or exhaust.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / 06

Possible causes

  • Deposits at the throttle or bypass channel, or gummed idle valve high
  • Extra load: stiff accessory drive, gearbox or converter medium
  • Intake or exhaust restricted (air filter, catalyst) medium
  • Idle valve or throttle actuator faulty, wrong learned value medium
  • Mechanical engine damage (low compression) low

Symptoms

  • Idle too low, engine shakes
  • Engine stalls when stopping or with A/C on
  • Check engine light after two trips

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0506

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication