OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0502

Vehicle Speed Sensor A Circuit Low

The vehicle speed signal A comes, depending on the maker, from a sensor on the gearbox, the transmission output speed, the wheel speeds via ABS/ESP or a CAN message; CARB explicitly names it as an input to be monitored. Despite its wording, all makers found check plausibility: the car is clearly moving (load, torque, overrun), yet the signal stays at zero. GM's 2018 tables use the transmission output speed: below 12 rpm (petrol) or 60 rpm (diesel) for 4.5 s, MIL on the first trip. Subaru (also in the Saab 9-2X) sets it below 1 km/h on overrun for over 4 s with the MIL at once; Saab's T5 after 4 s without signal above 1800 rpm. Electrical faults give the same picture.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number5 / 02

Possible causes

  • Speed or output speed sensor faulty high
  • Wire open or shorted to ground, connector corroded high
  • ABS module sends no speed signal medium
  • Tone wheel damaged or sensor dirty low

Symptoms

  • Check engine light on
  • Speedometer dead or jumping
  • Cruise control not working
  • Automatic shifts harshly or wrongly

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0502

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication