OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P04F4

Catalyst Heater Circuit Low Bank 1

An electrically heated catalyst has a heating disc ahead of the catalyst so that it works soon after a cold start; Emitec's EMICAT runs on 12, 24 or 48 V and draws up to about 300 A. It is in series production on 48-volt mild-hybrid diesel vans since 2022. P04F4 concerns the heated catalyst of bank 1. The code means the measured voltage or current in the heater circuit is too low for the commanded state – typically the feed or the heating element is shorted to ground; depending on the driver also an open circuit. The heater is switched off. No manufacturer document available to us uses this code – Ford, for example, states that heated catalyst monitoring is not supported – so thresholds and warning-lamp logic are not documented; the description follows CARB and patents for the same part.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / F4

Possible causes

  • Feed shorted to ground (chafed at the exhaust, heat) high
  • Heating disc shorted to its housing (insulation damage) medium
  • Connector wet or corroded medium
  • Power switch or module faulty low

Symptoms

  • Check engine light on (depending on the maker)
  • Higher emissions after a cold start
  • Otherwise usually unremarkable

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P04F4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication