P04F3
Catalyst Heater Supply Voltage Bank 2
An electrically heated catalyst has a heating disc ahead of the catalyst so that it works soon after a cold start; Emitec's EMICAT runs on 12, 24 or 48 V and draws up to about 300 A. It is in series production on 48-volt mild-hybrid diesel vans since 2022. P04F3 concerns the heated catalyst of bank 2 – no production vehicle with two heated catalysts is known. The code monitors the supply voltage of the heater: if it lies outside its window when heating is requested, the heater cannot deliver its power and is limited or switched off, so the catalyst lights off later. A Subaru patent detects faults in the supply path when the heater is commanded. No manufacturer document available to us uses this code – Ford, for example, states that heated catalyst monitoring is not supported – so thresholds and warning-lamp logic are not documented; the description follows CARB and patents for the same part.
Possible causes
- 48 V or high-voltage supply weak (battery, charge, cold, DC-DC converter) high
- Fuse, relay or power switch faulty medium
- Contact resistance or corrosion at high-current connector or ground medium
- Module or voltage measurement faulty low
Symptoms
- Check engine light on (depending on the maker)
- Higher emissions after a cold start
- Otherwise usually unremarkable
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P04F3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.