OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P04E8

EGR Temperature Sensor D Circuit High

Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. Sensor D is the fourth of up to four EGR temperature sensors, conceivable on engines with high- and low-pressure EGR and a sensor before and after each cooler; it is usually an NTC whose low voltage means hot. No manufacturer document available to us uses sensor D; the description follows CARB and Ford's checks on sensor B as a comparison. P04E8 means the signal is above its upper limit – an open circuit in sensor, connector, line or ground, or a short to positive; the reading looks very cold. For sensor B Ford uses above 4.95 V. A substitute value is used.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / E8

Possible causes

  • Connector off or loose, or pin corroded high
  • Sensor open internally (heat damage) medium
  • Sensor ground line open medium
  • Signal line shorted to positive low

Symptoms

  • Check engine light on
  • Usually no change in driving
  • EGR possibly reduced, higher NOx

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P04E8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication