OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P04E6

EGR Temperature Sensor D Circuit Range/Performance

Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. Sensor D is the fourth of up to four EGR temperature sensors, conceivable on engines with high- and low-pressure EGR and a sensor before and after each cooler; it is usually an NTC whose low voltage means hot. No manufacturer document available to us uses sensor D; the description follows CARB and Ford's checks on sensor B as a comparison. P04E6 means the signal is electrically valid but implausible – for example it differs from other temperatures after a long stop, does not react when EGR opens, or freezes. Ford compares sensor B with intake and charge air after at least 6 hours off and flags more than 25 °C.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / E6

Possible causes

  • Sensor drifting (soot or oil crust, ageing) high
  • Contact resistance in connector or harness (heat, corrosion) medium
  • Real temperature deviation: EGR cooler or bypass faulty, valve sticking medium
  • Comparison sensor faulty low

Symptoms

  • Check engine light on
  • Usually no change in driving
  • EGR possibly reduced, higher NOx

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P04E6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication