P04E3
Crankcase Ventilation Hose Connection Sensor Circuit High
The crankcase ventilation (PCV) system routes blow-by gas from the crankcase into the intake; CARB requires a disconnection between crankcase and intake to be detected. GM's 2.0-litre LSY has a pressure sensor in the PCV hose: with the hose connected it must see a pressure drop that grows with air flow, plus pressure pulses from the pistons. Ford reports the same sensor type as crankcase pressure sensor A (P051A ff). P04E3 means the sensor signal is too high: GM's LSY sets it at 95.5 % of 5 V or more (about 4.78 V) in 1280 of 1600 samples, MIL after two trips. Typical is a signal line shorted to 5 V or battery voltage; an open sensor ground can also pull the signal up. The disconnection check P04DB is then suspended.
Possible causes
- Signal line shorted to 5 V or battery voltage high
- Sensor ground open medium
- Sensor faulty medium
- Corroded or wet connector low
Symptoms
- Check engine light on
- Disconnection check P04DB does not run
- Usually no change in driving
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P04E3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.