OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P04E2

Crankcase Ventilation Hose Connection Sensor Circuit Low

The crankcase ventilation (PCV) system routes blow-by gas from the crankcase into the intake; CARB requires a disconnection between crankcase and intake to be detected. GM's 2.0-litre LSY has a pressure sensor in the PCV hose: with the hose connected it must see a pressure drop that grows with air flow, plus pressure pulses from the pistons. Ford reports the same sensor type as crankcase pressure sensor A (P051A ff). P04E2 means the sensor signal is too low: GM's LSY sets it at 4.3 % of 5 V or less (about 0.22 V) in 1280 of 1600 samples, MIL after two trips. With this ratiometric sensor an open signal line also reads low, as does a missing 5 V reference. The disconnection check P04DB is then suspended.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / E2

Possible causes

  • Signal line open or shorted to ground high
  • 5 V reference open or shorted (often shared with other sensors) medium
  • Connector not latched or corroded medium
  • Sensor faulty medium

Symptoms

  • Check engine light on
  • Disconnection check P04DB does not run
  • Usually no change in driving

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P04E2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication