P04DC
Fuel Fill Door Position Sensor/Switch Circuit Range/Performance
Plug-in and some full hybrids keep the fuel tank sealed while driving, separated from the charcoal canister by a valve. When the driver presses the fuel button, the system opens the valve, lets the pressure escape into the canister and only then unlocks the filler door. A switch reports whether the door is open or closed, so that the tank can be sealed again afterwards. P04DC means the door switch signal is electrically valid but implausible. A GM patent detects refuelling from a rising fuel level at standstill with low tank pressure; if the switch reported open for less than about 20 s, or closed for too long, it is faulty. A Ford patent sets a fault if the fuel level rose and the car drove off without the switch ever reporting open – the valve then stays open and the driver is warned. If the door state is unknown, the system leaves the tank open to the canister as a precaution and suspends the leak tests. No manufacturer document available to us uses this code; the description follows CARB's input component rules and patents for the door switch.
Possible causes
- Switch mechanically jammed or misadjusted (reports one state permanently) high
- Door or actuator damaged or missing medium
- Signal or connector fault with a valid but wrong level medium
- Fuel level sensor faulty (refuelling misdetected) low
Symptoms
- Check engine light on
- Fuel door open message although the door is closed, or missing when it is open
- Door may not open or only after a delay
- EVAP readiness not set
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P04DC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.