OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P04DA

Closed Loop EGR Control At Limit - Flow Too High

Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. P04DA is the counterpart of P04D9: the control cannot lower the flow far enough even at the end of its range. CARB requires this for petrol engines from model years 2019–21 and for diesels. Ford's 6.7-litre diesel sets it when the desired minus the measured EGR rate stays below −60 points for 20 s with EGR in closed loop. Too much exhaust in the cylinder causes soot, rough running and, on petrol engines, misfire up to stalling at idle.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / DA

Possible causes

  • EGR valve not closing (soot at the seat, stuck open) high
  • Air mass meter reading too little fresh air (EGR rate calculated too high) medium
  • Position or EGR temperature sensor giving a wrong value medium
  • Intake or exhaust throttle wrong (pressure difference too large) low

Symptoms

  • Check engine light on
  • Rough idle, jerking
  • Smoke or soot (diesel), possibly stalling at idle (petrol)

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P04DA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication