P04D3
Exhaust Brake Input Circuit
The exhaust brake input is the driver's request for the exhaust or engine brake – a button or stalk on diesel pick-ups and trucks. On GM's 6.6-litre L5P, for example, the button must be pressed again after every start. GM uses the exhaust brake status as an enable condition for other emission monitors, which is why CARB requires the input to be checked. No manufacturer table available to us lists P04D3–P04D7; Hino's J08E truck engine checks P04D5 before its exhaust brake function test. P04D3 is the general circuit fault of the request input, used where the module cannot resolve the fault type further – an open circuit or, on bus-connected buttons, an invalid message.
Possible causes
- Exhaust brake button faulty (contact, lighting board) high
- Open wire or connector between button and module medium
- Fault in an intermediate module or bus message low
- Engine module or software low
Symptoms
- Exhaust brake cannot be switched on, button lamp off or wrong
- Possibly check engine light
- More load on the service brakes downhill
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P04D3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.