P04CE
EGR Temperature Sensor C Circuit
Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. The code standard allows up to four EGR temperature sensors, A to D – for example before and after the cooler, or in the high- and low-pressure circuits; which is which depends on the maker. Sensor C is the third of them, usually an NTC whose low voltage means hot. P04CE is its general circuit fault, without separating low and high. FCA lists sensor C codes for its part 68142905A (Ram 2014 6.4 and 3.0 litre, Jeep and Dodge 3.6 Pentastar 2016) together with P040B, P0401 and P2457. Thresholds are not published. Without a valid temperature the EGR flow model is wrong, so the module uses a substitute value or switches EGR off.
Possible causes
- Open or poor contact in signal or ground line high
- Connector or wire at the sensor corroded or worn by heat and vibration high
- Sensor faulty (element broken or sooted) medium
- Engine module input low
Symptoms
- Check engine light on
- Usually no change in driving (EGR on a substitute value or off)
- Possibly EGR flow or cooler codes (P0401, P2457)
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P04CE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.