OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P04B8

Fuel Fill Door Position Sensor/Switch Circuit

Plug-in and some full hybrids keep the fuel tank sealed while driving, separated from the charcoal canister by a valve. When the driver presses the fuel button, the system opens the valve, lets the pressure escape into the canister and only then unlocks the filler door. A switch reports whether the door is open or closed, so that the tank can be sealed again afterwards. P04B8 is the general circuit fault or open circuit of the door switch: the module cannot read the door state. If the door state is unknown, the system leaves the tank open to the canister as a precaution and suspends the leak tests. No manufacturer document available to us uses this code; the description follows CARB's input component rules and patents for the door switch.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / B8

Possible causes

  • Wire or connector at the door switch open (side panel, moisture) high
  • Switch or sensor faulty internally medium
  • Ground or supply interrupted medium
  • Module input faulty low

Symptoms

  • Check engine light on
  • Fuel door open message although the door is closed, or missing when it is open
  • Door may not open or only after a delay
  • EVAP readiness not set

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P04B8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication