OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P04B7

Fuel Fill Door Position Sensor/Switch Circuit Intermittent/Erratic

Plug-in and some full hybrids keep the fuel tank sealed while driving, separated from the charcoal canister by a valve. When the driver presses the fuel button, the system opens the valve, lets the pressure escape into the canister and only then unlocks the filler door. A switch reports whether the door is open or closed, so that the tank can be sealed again afterwards. P04B7 means the door switch signal drops out or jumps briefly – the state changes without the door moving, for example while driving. Typical are loose contacts or a broken wire at the bend into the door area. If the door state is unknown, the system leaves the tank open to the canister as a precaution and suspends the leak tests. No manufacturer document available to us uses this code; the description follows CARB's input component rules and patents for the door switch.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / B7

Possible causes

  • Loose contact in the connector, pins pushed back high
  • Broken wire at the bend or grommet medium
  • Switch bouncing or worn, door seated loosely medium
  • Module input faulty low

Symptoms

  • Check engine light on
  • Fuel door open message although the door is closed, or missing when it is open
  • Door may not open or only after a delay
  • EVAP readiness not set

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P04B7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication