OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P04B2

Refueling Vapor Control Valve Circuit High

The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. Plug-in hybrids and range extenders with a sealed, pressurised tank have an electric valve in the vapour line between tank and canister. It is normally closed and opens before refuelling, so that the tank is depressurised – the filler flap is only released then – and refuelling vapour reaches the canister (Ford patent). P04B2 means the control wire is shorted to positive: the valve cannot be driven and does not open, the driver may switch off for protection. The tank cannot be depressurised before refuelling and refuelling vapour cannot reach the canister. No manufacturer document available to us uses this code – Ford reports its tank isolation valve as P2418/P2450 – so the description follows CARB and the component patent.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / B2

Possible causes

  • Control wire touching battery positive high
  • Valve coil with shorted turns (driver overcurrent) medium
  • Corrosion in the connector medium
  • Driver in the control module low

Symptoms

  • Check engine light on
  • Filler flap does not open after pressing the refuel button, or only after a delay
  • EVAP readiness not set

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P04B2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication