OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P04B1

Refueling Vapor Control Valve Circuit Low

The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. Plug-in hybrids and range extenders with a sealed, pressurised tank have an electric valve in the vapour line between tank and canister. It is normally closed and opens before refuelling, so that the tank is depressurised – the filler flap is only released then – and refuelling vapour reaches the canister (Ford patent). P04B1 means the control wire is shorted to ground, so the valve is permanently energised. With a normally closed valve the tank is then always connected to the canister: daily evaporation loads the canister and the tank cannot be sealed for the leak test. No manufacturer document available to us uses this code – Ford reports its tank isolation valve as P2418/P2450 – so the description follows CARB and the component patent.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / B1

Possible causes

  • Control wire chafed against ground (underbody, tank area) high
  • Valve coil shorted internally medium
  • Moisture in the connector medium
  • Driver in the control module low

Symptoms

  • Check engine light on
  • Possibly fuel smell
  • EVAP readiness not set

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P04B1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication