P04AC
EVAP System Purge Control Valve B Circuit Low
The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. Purge valve B is a second electric purge valve, usually for the high-load purge line of a turbo engine, which purges to the compressor inlet when there is boost in the manifold (Ford patent). Many makers solve this path with one purge valve and passive check valves instead – Ford tests it as P04F0 – and then have no valve B. CARB requires every purge path to be checked. P04AC means the control wire of purge valve B is shorted to ground: the valve stays energised and open, purging is uncontrolled and the mixture may run rich, especially at idle or after refuelling. No manufacturer document available to us uses this code; the description follows CARB and the comparable purge valve A checks (for GM P0443/P0458/P0459).
Possible causes
- Control wire of purge valve B chafed against ground high
- Coil shorted internally medium
- Moisture in the connector medium
- Driver in the engine module low
Symptoms
- Check engine light on
- Rough idle, rich mixture
- Starting problems after refuelling
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P04AC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.