P04A9
Exhaust Pressure Control Valve B Position Sensor/Switch Circuit High
An exhaust pressure control valve is an electrically driven flap in the exhaust with a position sensor or end-position switch, usually inside the actuator. Valve B is the second such flap; Bentley's V8 assigns A to bank 1 and B to bank 2. Documented uses are the flap behind the particulate filter of VW's and Audi's 2.0 TDI, which raises back pressure for the low-pressure EGR, and the sound flaps of Audi and Bentley. P04A9 means valve B's position signal is above its window – open signal or short to positive. No manufacturer document available to us uses this code; the description mirrors the valve A counterpart P048E and CARB's monitoring requirement for input and output components.
Possible causes
- Actuator electronics (position sensor) faulty high
- Signal or ground wire open medium
- Connector corroded medium
- Signal shorted to positive low
Symptoms
- Check engine light on
- Flap without function, exhaust sound changed
- VW/Audi TDI: EGR fault P0401 possible
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P04A9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.