P04A7
Exhaust Pressure Control Valve B Position Sensor/Switch Circuit Range/Performance
An exhaust pressure control valve is an electrically driven flap in the exhaust with a position sensor or end-position switch, usually inside the actuator. Valve B is the second such flap; Bentley's V8 assigns A to bank 1 and B to bank 2. Documented uses are the flap behind the particulate filter of VW's and Audi's 2.0 TDI, which raises back pressure for the low-pressure EGR, and the sound flaps of Audi and Bentley. P04A7 means valve B's position signal is valid but does not fit the commanded position or the learned end stops. No manufacturer document available to us uses this code; the description mirrors the valve A counterpart P048C and CARB's monitoring requirement for input and output components.
Possible causes
- Flap or shaft corroded or coked (stiff) high
- End positions not relearned after replacement medium
- Position sensor in the actuator drifting medium
- Contact resistance in the connector low
Symptoms
- Check engine light on
- Flap without function, exhaust sound changed
- VW/Audi TDI: EGR fault P0401 possible
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P04A7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.