OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P049E

EGR B Control Position Exceeded Learning Limit

Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. Circuit B is the second EGR path; on diesels with two circuits it is the low-pressure EGR, which takes exhaust after the particulate filter and feeds it in before the turbo compressor (GM diesels 2016–18, FCA's 2.2 and 3.0 diesels). P049E is the counterpart of P049D for valve B: the learned zero point of its position sensor lies outside the permitted window. GM lists it only in a fault group of its low-pressure EGR (whose position sensor is sensor C there, P044C/P044D), and in the 2016 calibration it is explicitly disabled; thresholds are not published. The description therefore follows GM's P049D strategy by analogy. Low-pressure EGR position control is then switched off.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / 9E

Possible causes

  • Low-pressure EGR valve sooted, does not close fully high
  • Position sensor of the low-pressure valve faulty or shifted medium
  • Valve replaced without teaching in medium
  • Harness or connector of the low-pressure valve low

Symptoms

  • Check engine light on
  • EGR switched off, usually no noticeable change
  • Higher NOx

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P049E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication