OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P049D

EGR A Control Position Exceeded Learning Limit

Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. P049D checks the learned zero point – the fully closed position – of EGR valve A. The module learns the position sensor voltage with the valve closed, at GM during the after-run following ignition off; if the learned value lies outside a window (GM 2018: 83.5–93.5 % of 5 V, GM 2016: 16.4–25.1 %) or the values scatter too much (GM Duramax LML above 30 %), the code sets – MIL after two trips at GM, immediately after learning at Ford. Usually soot at the seat keeps the valve from closing, or a new valve was not taught in.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / 9D

Possible causes

  • Soot or deposits at the valve seat, valve does not close fully high
  • Position sensor A faulty or characteristic shifted medium
  • New or cleaned valve not taught in, or wrong part medium
  • Position sensor circuit fault as the primary cause low

Symptoms

  • Check engine light on
  • Usually no driveability effect
  • EGR possibly switched off, rough idle if the valve stays open

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P049D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication