OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0496

EVAP System High Purge Flow

The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. P0496 means vapour flows into the intake although the module is not purging – usually a purge valve that leaks or sticks open. GM and Saab seal the system after a cold start with the engine running; if tank vacuum exceeds 2491 Pa for 5 s, the code sets (fuel 10–90 %, MIL after two trips). Ford, which replaced its old code P1450 with P0496, also sets it for excessive vacuum during the leak test, for example with a vent valve stuck closed. Hard starting right after refuelling is typical.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / 96

Possible causes

  • Purge valve leaking or stuck open (charcoal dust in the seat) high
  • Vent valve stuck closed or vent filter or line blocked medium
  • Vapour line kinked or blocked low
  • Tank pressure sensor reading wrong low

Symptoms

  • Check engine light on
  • Hard or long starting right after refuelling
  • Rough idle, rich fuel trim
  • Hissing vacuum when opening the fuel cap

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0496

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication