P048F
Exhaust Pressure Control Valve A Position Sensor/Switch Circuit Intermittent/Erratic
An exhaust pressure control valve is an electrically driven flap in the exhaust with a position sensor or end-position switch, usually inside the actuator. Valve A is the first such flap; Bentley's V8 assigns A to bank 1 and B to bank 2. Documented uses are the flap behind the particulate filter of VW's and Audi's 2.0 TDI, which raises back pressure for the low-pressure EGR, and the sound flaps of Audi and Bentley. P048F means valve A's position signal jumps, drops out briefly or changes faster than physically possible. Bentley stores sporadic sensor faults under the low code with a sporadic status instead. No manufacturer document available to us uses this code; the description follows the sibling codes P048B–P048E and CARB.
Possible causes
- Loose contact or corrosion at the actuator connector high
- Wire broken by vibration or heat medium
- Position sensor worn medium
Symptoms
- Check engine light on
- Flap without function, exhaust sound changed
- VW/Audi TDI: EGR fault P0401 possible
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P048F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.