OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P048E

Exhaust Pressure Control Valve A Position Sensor/Switch Circuit High

An exhaust pressure control valve is an electrically driven flap in the exhaust with a position sensor or end-position switch, usually inside the actuator. Valve A is the first such flap; Bentley's V8 assigns A to bank 1 and B to bank 2. Documented uses are the flap behind the particulate filter of VW's and Audi's 2.0 TDI, which raises back pressure for the low-pressure EGR, and the sound flaps of Audi and Bentley. P048E means valve A's position signal is above its window – an open signal pulled up, or a short to positive. VW's 2.0 TDI third generation of 2015 sets it together with P048B, P0475, P0477 and P0478: the flap is welded into the pipe, so with electronic faults only the actuator is replaced – an electrostatic-sensitive part that must be scrapped if dropped.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / 8E

Possible causes

  • Actuator electronics (position sensor) faulty high
  • Signal or ground wire open medium
  • Connector corroded medium
  • Signal shorted to positive low

Symptoms

  • Check engine light on
  • Flap without function, exhaust sound changed
  • VW/Audi TDI: EGR fault P0401 possible

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P048E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication