P048D
Exhaust Pressure Control Valve A Position Sensor/Switch Circuit Low
An exhaust pressure control valve is an electrically driven flap in the exhaust with a position sensor or end-position switch, usually inside the actuator. Valve A is the first such flap; Bentley's V8 assigns A to bank 1 and B to bank 2. Documented uses are the flap behind the particulate filter of VW's and Audi's 2.0 TDI, which raises back pressure for the low-pressure EGR, and the sound flaps of Audi and Bentley. P048D means valve A's position signal is below its permitted voltage window – the signal wire is shorted to ground or the sensor's 5 V supply is missing. Bentley's Continental and Flying Spur V8 of 2023 report it for bank 1 together with P048B; the bulletin advises checking wiring and contacts, otherwise replacing the actuator and carrying out the basic setting.
Possible causes
- Signal wire shorted to ground (chafed at the underbody) high
- Position sensor or actuator faulty internally high
- 5 V sensor supply open or shorted medium
- Moisture or corrosion in the connector medium
Symptoms
- Check engine light on
- Flap without function, exhaust sound changed
- VW/Audi TDI: EGR fault P0401 possible
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P048D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.