OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P048C

Exhaust Pressure Control Valve A Position Sensor/Switch Circuit Range/Performance

An exhaust pressure control valve is an electrically driven flap in the exhaust with a position sensor or end-position switch, usually inside the actuator. Valve A is the first such flap; Bentley's V8 assigns A to bank 1 and B to bank 2. Documented uses are the flap behind the particulate filter of VW's and Audi's 2.0 TDI, which raises back pressure for the low-pressure EGR, and the sound flaps of Audi and Bentley. P048C means valve A's position signal is electrically valid but does not match the commanded position or the learned end positions. It is documented only on VW's and Audi's 2.0 TDI of 2009–13, together with P047F, P048A, P048B and P0401, caused by the corroded, sticking flap shaft. After replacing the actuator, the end positions must be relearned.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / 8C

Possible causes

  • Flap or shaft corroded or coked (stiff) high
  • End positions not relearned after replacement medium
  • Position sensor in the actuator drifting medium
  • Contact resistance in the connector low

Symptoms

  • Check engine light on
  • Flap without function, exhaust sound changed
  • VW/Audi TDI: EGR fault P0401 possible

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P048C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication