P048B
Exhaust Pressure Control Valve A Position Sensor/Switch Circuit
An exhaust pressure control valve is an electrically driven flap in the exhaust with a position sensor or end-position switch, usually inside the actuator. Valve A is the first such flap; Bentley's V8 assigns A to bank 1 and B to bank 2. Documented uses are the flap behind the particulate filter of VW's and Audi's 2.0 TDI, which raises back pressure for the low-pressure EGR, and the sound flaps of Audi and Bentley. P048B is the general circuit fault or open circuit of valve A's position sensor or end switch. VW's 2.0 TDI of 2009–13 sets it with a corroded flap; on the 2015 engine it appears with P048E, P0475, P0477 and P0478 and the actuator with its integrated electronics is replaced; Bentley's V8 of 2023 reports it for bank 1 together with P048D. As the sensor sits in the actuator, a circuit fault often means actuator electronics.
Possible causes
- Actuator with integrated position sensor faulty high
- Connector or wire at the underbody corroded, chafed or open high
- Engine module (sensor supply or input) low
Symptoms
- Check engine light on
- Flap without function, exhaust sound changed
- VW/Audi TDI: EGR fault P0401 possible
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P048B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.