OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0488

EGR Throttle Control Circuit A Range/Performance

Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. The EGR throttle is a regulating flap ahead of the intake manifold on diesels: by closing partly it lowers manifold pressure below exhaust back pressure so that enough exhaust is recirculated, and it also helps filter regeneration and shuts off air at engine stop. It is usually a DC motor with position sensor. GM and Ford report this flap under P02E0 ff; no manufacturer document available to us uses this code. P0488 is its function check: the actual position reported by the sensor deviates from the target for too long, or the position signal is implausible – typically a coked, stiff flap or a broken gear. The flap then goes to its rest position or the engine enters limp mode, and the EGR rate cannot be controlled.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / 88

Possible causes

  • Flap coked by soot and oil mist (EGR plus crankcase ventilation) high
  • Actuator gear or motor worn or broken medium
  • Position sensor in the flap faulty or implausible medium
  • Corrosion on flap or housing low

Symptoms

  • Check engine light on
  • Loss of power or limp mode possible
  • Shaking when the engine is switched off
  • Filter regeneration does not complete

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0488

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication