OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0487

EGR Throttle Control Circuit A/Open

Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. The EGR throttle is a regulating flap ahead of the intake manifold on diesels: by closing partly it lowers manifold pressure below exhaust back pressure so that enough exhaust is recirculated, and it also helps filter regeneration and shuts off air at engine stop. It is usually a DC motor with position sensor. GM and Ford report this flap under P02E0 ff; no manufacturer document available to us uses this code. P0487 means its drive circuit is open or has a general circuit fault, detected by the output stage. The flap then stays open, so the EGR rate cannot be raised enough and filter regeneration may be blocked.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / 87

Possible causes

  • Connector at the flap corroded or loose, wire open high
  • Flap actuator motor faulty (winding open) medium
  • Pneumatic version: vacuum converter faulty low
  • Driver in the engine module low

Symptoms

  • Check engine light on
  • Loss of power or limp mode possible
  • Shaking when the engine is switched off
  • Filter regeneration does not complete

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0487

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication