OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0480

Fan 1 Control Circuit

The engine module switches the radiator fan either through a relay, whose coil it pulls to ground, or with a PWM signal to a fan control module. The circuit is an output that CARB requires to be checked continuously. P0480 concerns the control circuit of fan 1. GM sets it for an open circuit – 200 kΩ or more with the driver off, 50 of 63 samples, above 11 V, MIL after two trips – and reports a short to ground or positive as P0691/P0692; Saab models on GM technology set it after 5 s (relay) or 1 s (PWM). FCA bulletins also name it with the warning lamp. Ford's OBD summaries do not contain the code. If the fan stops, the engine can overheat in traffic and the air conditioning weakens at standstill.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / 80

Possible causes

  • Fan relay (coil open) or fan control module faulty high
  • Connector at fan or relay corroded, water ingress or pin pushed out high
  • Control wire open or shorted to ground medium
  • Fan motor or fan assembly faulty medium
  • Driver in the engine module low

Symptoms

  • Check engine light on
  • Radiator fan does not run, or runs constantly
  • Overheating at standstill or in traffic
  • Air conditioning weak at standstill

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0480

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication